Gasket material / source

Discussion in 'Multihulls' started by rturbett, Jun 16, 2020.

  1. rturbett
    Joined: Aug 2005
    Posts: 154
    Likes: 2, Points: 28, Legacy Rep: 35
    Location: FINGER LAKES, NY

    rturbett Senior Member

    As part of this Shark rebuild, I would like to put new gaskets on the daggerboard slots.

    3" width (slotted) 4 feet long,

    Please share your favorite material and source. The rubber ones have done well, but I'm open to anything lighter.
    Thanks,
    Rob
     
  2. rturbett
    Joined: Aug 2005
    Posts: 154
    Likes: 2, Points: 28, Legacy Rep: 35
    Location: FINGER LAKES, NY

    rturbett Senior Member

    ended up with rubber strip off amazon- would like to have gotten reinforced, but could not find it
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.