Fusion 360 error

Discussion in 'Software' started by fallguy, Jun 3, 2020.

  1. fallguy
    Joined: Dec 2016
    Posts: 3,353
    Likes: 442, Points: 93, Legacy Rep: 10
    Location: usa

    fallguy Senior Member

    My son is doing a project and getting an error. It says, 'stitching error, invalid body'.

    He is trying to stitch dev panels for a hull.

    I have asked him to get a login on boatdesign.net. Thanks for any replies.
     
  2. Dejay
    Joined: Mar 2018
    Posts: 520
    Likes: 83, Points: 28
    Location: Europe

    Dejay Senior Newbie

    Funny I had that error yesterday. In my case there was a tiny sliver of a curved surface not trimmed so the vertices didn't align and would form a T junction where three surfaces would meet in a line. So try to find the surface that gives you trouble and then double check (or triple check haha).

    BTW for developable surfaces Fusion 360 has an inspection tool that shows gaussian curvature. And you can unwrap with meshmixer but I haven't tried that yet.
     
  3. fallguy
    Joined: Dec 2016
    Posts: 3,353
    Likes: 442, Points: 93, Legacy Rep: 10
    Location: usa

    fallguy Senior Member

    Thanks!
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.