Unroll rurface in Rhino

Discussion in 'Software' started by Broen, Feb 23, 2007.

  1. Broen
    Joined: Feb 2007
    Posts: 2
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Denmark

    Broen New Member

    When I chose surface to unroll the program only respons: Select curves on surface to unroll! And nothing happens - whats wrong
     
  2. Raggi_Thor
    Joined: Jan 2004
    Posts: 2,457
    Likes: 64, Points: 0, Legacy Rep: 711
    Location: Trondheim, NORWAY

    Raggi_Thor Nav.arch/Designer/Builder

    You have to press enter on that question.
    Yiu have the possibility to select curves for a cut out for example, but you can press enter to select none.
     
  3. Raggi_Thor
    Joined: Jan 2004
    Posts: 2,457
    Likes: 64, Points: 0, Legacy Rep: 711
    Location: Trondheim, NORWAY

    Raggi_Thor Nav.arch/Designer/Builder

    And welcome to this forum :)
    I see it's your first post.
    You will find a lot of help here, try also the search menu close to the top.
     
  4. Broen
    Joined: Feb 2007
    Posts: 2
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Denmark

    Broen New Member

    Thank you

    My mistake was to have an almost similar object placed at point 0,0,0 so I could not see the new one
     

  5. Antisthenes
    Joined: Jan 2007
    Posts: 16
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Phoenix

    Antisthenes Junior Member

    Rhinoceros 4 RUlez!
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.