Mercury Alpha one Gen II Transom unit dimentions

Discussion in 'Sterndrives' started by Oko1978, May 7, 2018.

  1. Oko1978
    Joined: May 2018
    Posts: 2
    Likes: 0, Points: 1
    Location: Germany

    Oko1978 New Member

    Hello everyone,
    has anyone a Mercury Alpha One Gen II Transom Unit on hand and could provide me with the max. hight of the outer casing? The same would be needed for the interor part of the hull. I find it very hard to find any principal dimentions of the transom unit in metric dimentions if possible.
    Thanks alot for any help and Information!

    Best regards
    Oliver
     
  2. PAR
    Joined: Nov 2003
    Posts: 19,126
    Likes: 498, Points: 93, Legacy Rep: 3967
    Location: Eustis, FL

    PAR Yacht Designer/Builder

    Welcome to the forum.

    Murcury has this information on their web site. Full up dimensional drawings in metric.
     
  3. Oko1978
    Joined: May 2018
    Posts: 2
    Likes: 0, Points: 1
    Location: Germany

    Oko1978 New Member

    Hello,

    thank you very much for the Information. However, I do get redirected to the german Homepage of Mercury. Here there is no link or material for drawings. Perhaps on the U.S. Homepage Mercury has more possiblities.

    I will try and keep on searching.

    Best regards
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.