Battery switch question

Discussion in 'OnBoard Electronics & Controls' started by Rich35758, Jun 25, 2008.

  1. Rich35758
    Joined: Jun 2008
    Posts: 1
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Alabama

    Rich35758 New Member

    I'm attempting to troubleshoot an alternator problem on a newly acquired boat. Prior to removing the alternator, I set the battery selector to OFF, yet still had 12V on the wire running from the switch common to the alternator. Is there any reason why the switch would send juice to the alternator "+" terminal when the battery switch is OFF? Thanks!
     
  2. Tim B
    Joined: Jan 2003
    Posts: 1,438
    Likes: 59, Points: 0, Legacy Rep: 841
    Location: Southern England

    Tim B Senior Member

    It shouldn't do that. Check the resistance between the switch contacts in each position.

    Cheers,

    Tim B.
     
  3. bntii
    Joined: Jun 2006
    Posts: 731
    Likes: 97, Points: 28, Legacy Rep: 1324
    Location: MD

    bntii Senior Member

    Isolate the circuit- That is determine if the source of voltage you are seeing is perhaps getting to you test point by some other route. Is there a paralleling switch? Is there a hot wire going to the ignition circuit that is common to the alternator cable and a starting battery?
    Also- are you testing the correct pole on the switch?
    Also- is the boat wired so that the alternator cable is in fact not switched but is just a 'pass though' cable on the rotary switch lugs?
    Many boats suffer from some small circuit which serves to parallel the house and starting cells quite by accident.
     
    1 person likes this.
  4. CDK
    Joined: Aug 2007
    Posts: 3,324
    Likes: 148, Points: 63, Legacy Rep: 1819
    Location: Adriatic sea

    CDK retired engineer

    This depends on the concept the boat builder had in mind when the wiring was done. If you see the starter motor, alternator and battery as a unit (that is normally the case), setting the battery switch to off simply means that no current is drawn externally. The advantage is that you do not need a 500 Amp switch but can use a much smaller one.
    In a twin engine installation you can switch between 2 or more batteries to allow starting from battery A or B or both. In that case you need a heavy switch that can handle the starting current.
     

  5. sr71
    Joined: Sep 2008
    Posts: 1
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: NJ

    sr71 New Member

Loading...
Similar Threads
  1. sdowney717
    Replies:
    9
    Views:
    2,267
  2. CDK
    Replies:
    4
    Views:
    2,718
  3. kapnD
    Replies:
    8
    Views:
    640
  4. BoraBora
    Replies:
    16
    Views:
    2,540
  5. sdowney717
    Replies:
    0
    Views:
    2,409
  6. sdowney717
    Replies:
    1
    Views:
    1,480
  7. sdowney717
    Replies:
    26
    Views:
    2,751
  8. sdowney717
    Replies:
    2
    Views:
    1,636
  9. sdowney717
    Replies:
    30
    Views:
    6,509
  10. sdowney717
    Replies:
    13
    Views:
    1,883
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.