Hello all, I find myself in a great quandary. I find my 10' livingston with its 10hp motor a tad bit slow and hard to run for longer distances,...
Hi guys I recently bought a 16' 86 sweetwater pontoon and i am considering turning it into a tritoon. A few issues I have are finding a correct...
Hey all, it's probably a long shot as there is no information for my boat online. I'm looking to replace the transom and can't find any info on...
My dinghy has a flat transom. It's vertical, too. What does the water flow look like behind such a transom at a modest speed like 3 mph? Does...
Dear everyone, Recently I got a bit stuck with one structural design problem. It is how to properly design nad analyse transom that carries 2 x...
Hi All, I am relatively new to glass work. Been reading a bit, but couldn't find exactly the info I am looking for. I am working to give new life...
Hi everyone: I bought a Silverton 330 boat totally wrecked the only thing working is the hull. I stripped the boat completely. It used to have...
I was wondering if this is possible to repair. The engine fell off when the last owner hit a pot hole and it looks like it took alot of fiber...
Help needed - Due to pandemic my outboard is still at the shop; Meanwhile I am building a small runabout woody and need to know the minimum...
I am new at DIY boating, I am thinking of renovating the transom of a 1999 Haines Hunter Breeze 470. over the years it has had some bits put...
Does the transom edge need to be sharp on my boat? I calculate a Froude number of about 0.9, based on a 9m/s velocity and a 10 meter long hull....
Hey everyone! If you want the easiest, strongest, and best product to repair your transom with, take a look at CarbonBond Pourable Ceramic Transom...
Hi all, and thanks in advance for advice. Last year I put together a great kit for a 12' wood-duck hybrid kayak. I learned a lot about working...
I want to build up a core to 1 3/4" for a transom. I will use two pieces of 1/2" and one 3/4" high density M200. The lamination schedule for...
My name is Reid, Im 17 and still in HS but the ocean is my passion and I have taken up a project building a 30' Aluminum Pilothouse boat. I am...
Below the waterline of the transom the paint peels off by hand, between the paint and the wood is a thin white layer of crust. Is this the early...
New Aft Deck section, with butterfly hatches for Propane Locker (small) and lazzarette storage (large). Bullworks are increased across back...
Finished Transom and nesting Swim step
Final product at anchor in Kaneohe Bay, Oahu, Hawaii Lovely spot to show off the boat.
Boat with extedned hull ready for launch.