question

I don't know why this happens. I got the offset table from my school project. I put them together as seen in the picture. But when i try to open that in maxsurf (dxf) it breaks into two piece and some lines became straight. WHAT CAN I DO?? I can't seem to find solution. Any advice?

Hello I am replacing the main bulkhead in a 1975 Ranger 26 because it was rotted through. I have cut the new piece based on the old piece, except that the few inches near the hull was rotted through and I can't get an exact shape. I have found mixed information about the space between the...

Greetings and good day, This is my first post here. I have been browsing the forum for a while, collecting pearls of wisdom and experience. A little bit about myself: I have been sailing in childhood for many years. However, I have far less experience in boat design and multihull than many...