power catamaran

Hello everyone, I am currently developing an 8.5 m planing power catamaran with a center-console layout, and I would appreciate the opinion of experienced naval architects, catamaran designers and boat builders regarding the minimum tunnel clearance required for good behavior in short and...

Hi, is there anyone out there skilled in using design software for boats, or that has specific design capability for power catamarans. I have a very good alluminium boat builder but their designs are dated and i want to update them with: A) A Foil B) just a range of improvements on their...

I propose you a spreadsheet application for the estimation of the drag and of the power to install for a power catamaran, for speeds in the Froude range 0,3 to 1,0. Conditions of validity are : ** Length Beam ratio Lw/Bw > 7 ** Length Displacement ratio Lw/Dc^(1/3) > 6,5 (Length, Beam...

In the low DL/L ratio power multihull area, it looks like there are a a couple approaches to hull section and profile. It's a small regime, so there aren't a lot of examples out refer to. My personal interests are in fuel-efficient cruising, moderate seakeeping, and transportability, which...

These 2150 Center Console Bay Cat molds were in production from the late 80's until 2010 when the original company Pro Sports shut down due to the economy. Known as the Pro Cat’s model line with many dealers throughout the United States and Europe ….. Shortly thereafter we purchased this...

Looking for molds and/or hulls - Any ideas?