Hello, I’m interested in sailing and have been wondering about hull shapes for sailboats. I’ve found information about the type of hull I’ve been...
Good Evening, I am Diganta Ghosh from India studying Naval Architecture and Ocean Engineering in Indian Maritime University, Visakhapatnam. My...
Hello, soon (in a few months) I'll be building a Spira Albion 19' (first time builder). Plans call for a 5/8" on the bottom of the hull and I was...
Anyone have any information about a Simpson 8.3m sailing Catamaran . I have just purchased one, it needs two fixed keels repaired or daggerboards...
I'm designing a racing flatwater SUP for myself, I just wanted to know If my reasoning is correct. So, I weight 85kg, and I estimate the final...
Looking for molds and/or hulls - Any ideas?
So I want to learn to how to determine how much in material I would need to build a 30-40 ft Cat hull out of the following materials. Lets say if...
Hi, I'm planning a boat on request, a small challenge, but I would like to avoid trivial mistakes, but I'm not expert at all. Below are the...
I am wanting to export a hull model from Maxsurf to AVEVA Surface and Compartment but I can't seem to find a file format which is supported by...
Hello. I'm doing CFD simulation of the hull and i'm getting outputs for x pressure force, y pressure force, z pressure force and shear forces....
This is a personal try in hull and boat design, made with Blender 3D. The start project can be downloaded here....
Hello , what do You think, what is the best way to join hull with deck : lodz https://ibb.co/ghb4Nb . It should be solid,waterproof and easy to...
I'm investigating the possibilities of building something like the Sienna 19 or Secret 33 from Scruffie Marine and use as a canal camper. The...
Deckcap component layup in mold.
New deckcap component pulled form mold and fitted with butterfly deck hatches for lazzarette and propane locker access.
Deck Cap component roughly fitted and ready for faring.
Mold was built to cast the deckcap component. Used 1/2 sections of PVC pipe to create the "negative" mold to cast hatch gutters for...
Added water tank (40 Gal) under lazzarette floor. Created two sections, one for Propane Locker and the other a lazzarette. Casted curved...
New structural transom installed on new extension section after layup and mold removal.
Mold made from MDF wrap around the existing hull to form an extended section "sugar scoop" on the hull. Glass layhou with epoxy resin...