divinycell | Boat Design Net

Thread

I am removing teak covering boards and do not plan on replacing them. I would like to add a layer of 1/2 or 3/4' divinycell H80 as the...

Thread by: oceansswk, Sep 28, 2022, 5 replies, in forum: Boatbuilding

Thread

Little unconventional. I am not building a boat, I'm building a small car. I hope you can still help me. I am planning to use Divinycell H100 to...

Thread by: Joshua Alexander Saxon, Feb 13, 2022, 14 replies, in forum: Materials

Thread

As I am looking into foams for my beach catamaran project I have a hard time deciding between 3D Core PET Foam and Divinycell H80. Datasheets: 3D...

Thread by: eam, Aug 4, 2020, 3 replies, in forum: Fiberglass and Composite Boat Building

Thread

Hello, so I am in the process (the beginning rather) of building a Woods Design Quattro 14 beach catamaran. I am new to boat building and have a...

Thread by: eam, Jul 3, 2020, 5 replies, in forum: Fiberglass and Composite Boat Building

Boat Design Gallery

The hull finnsiwork is finally over!

Uploaded by: henrikb, Sep 10, 2002, 0 comments, in album: Member Album by henrikb

Boat Design Gallery

Designer: Hans Leander, ngermark Marin. The boat is beeing built using glass and vinylester on divinycell core. See more at my homepage...

Uploaded by: henrikb, Jul 24, 2002, 0 comments, in album: Member Album by henrikb

Boat Design Gallery

This is a picture from the buildingprocess of an one-off 33ft IMS racer/cruiser. The hull was glassed and faired when upside down. The picture is...

Uploaded by: henrikb, Jul 24, 2002, 1 comments, in category: Boatbuilding