three layers veneer impregnated in epoxy; first two layers diagonally; third layer horizontally;three coats epoxy on the outside. the framing was...
first layer of spruce planking is followed by a second layer of routered tongue and groove strip planking set in epoxy
42 ft hull turned for cold molding
most framing , most floors and 70% planking were rebuilt in laminated ash epoxy capsulated; the hull was rolled on two massive wood wheels; in...
The profile piece assures the alignment of the frames
More than half of total frames were reinforced by taking out rotten areas and fitting in epoxy laminated scarfed reinforcements. Old galvanised...
first we took the paint off the entire hull and deck. the hull structure is resorcinol one layer of 10mm cold molded mahogany over inner 9mm...
After +2000 NauticalMiles sailing passage from Italy Genova to Bucharest Romania ; the aging 40 ft Camper&Nicholson sloop ; the sea water...
our extra long spring passage sailing the Camper&Nicholson's 1963 sloop Rocquette Imperia/Italy to Constantza/Black Sea, 14 April - 18 June...
hull 20mm thick, up to keel/skeg 35 mm thick, cast bronze rudder &rudder shaft ; bronze keel shoe, Vetus bronze propeller; Vetus wet exhaust.
Designed and built Bucharest Romania 2003, Globalisation at work: boat was sold by means of internet advertising to Dutch Antilles. the...
Composite cruiser 27 test launching ;Giurgiu on Danube River.Photo taken secs before hitting water. Hull in polyester ; 50%vinylester and hand...
teak&epoxy deck over okoume plywood. cold molded interior; strip planking&cold molded cabin sides , details www.yacht.ro
The 212 hp Steyr Turbo injection Diesel supported by okoume cored fiberglass framing, foam cored deck and cabin, mahogany&epoxy opening front...
douglas fir-white spruce strip planking (routered) , West Sys. & barbed bronze nails fastened+3mm mahogany x 3 layers cold molded. Then all...
Black Sea Cruiser 27 ; designed &built 2003 in Bucharest Romania composite/vinylester lobsterboat hull, 212 hp Steyr Diesel; Vetus...
Just launched the boat after 3 yrs of building
This boat is an ongoing project that is being undertaken by students on the BTEC National Diploma in Boat Building & Design at Pembrokeshire...