ansys

Hi fellas, I am doing a project on cfd analysis of a composite-modelled catamaran. I have completed my catamaran model but facing issues with the GA of a catamaran. As for structural analysis, i want to know about the loads acting on various locations, apart from the passengers.

Hello, Recently I am trying to implement a FEA according to Common Structural Rules (CSR) for Strength Assesment for a Bulk Carrier, using ANSYS 2024R2. Currently, the geometry was created in Rhinoceros and was transferred then to ANSYS Spaceclaim. In Spaceclaim, the geometry in consisted of...

Hi, I am a beginner to Ansys AQWA and performing a hydrodynamic simulation for floating spar platform but i have recieved an error while solving the simulation setup for pressures and motions result. Error description: ILLEGAL CONNECTIVITY. Element 18882 is joined to element 25371 and element...

Hi all, Currently have a ship hull which I have modelled in SpaceClaim and meshed in mechanical. In Mechanical, I am trying to constrain all of the nodes at fore and aft ends of the hull (see photo attached) in order to carry out stress/strain analyses. These nodes will be constrained at...

Hi, For a student project related to the 'Radiation-Diffraction' analysis of a floating offshore wind turbine (FOWT) foundation, I need some help with Ansys AQWA. I am working with a semi-submersible foundation that has three vertical columns (12 m dia) which are interconnected by bracings (0.5...

Dear Boat Design Forum, I start working with Ansys Aqwa recently, but I have general experience in Ansys. I am trying to simulate a mooring system of a floating LNG barge in Ansys Hydrodynamic Diffraction and Response Module. HD Module's solve feels nice and ends (with several warnings)...

Hello, I am senior student at the university and need urgent help on how to add mooring lines on ANSYS AQWA for Semi Submersible Floating Structure. If there is ordered way or screenshots on how to do it, it will be appreciated. Thanks in advance, Regards

I have a problem in validating the results of a ship motion from aqwa and maxsurf. When i calculated rao, the result look like same. But when i calculated rms of rolling motion. The result too much different. My assumption, i cant define how to calculate rms motion using wave frequency...

Hi there, I'm currently working on my interim report for my 4th year project on the structural analysis of naval ships as a result of underwater explosions. My original plan for the modelling stage was to create a detailed model of the midship section in Rhino and then import it into ANSYS...

Fea Analysis on Tank Region