Jabsco 4528 impeller pin, does it push or thread in

Discussion in 'Propulsion' started by sdowney717, Jul 3, 2018.

  1. sdowney717
    Joined: Nov 2010
    Posts: 1,175
    Likes: 85, Points: 58, Legacy Rep: 274
    Location: Newport News VA

    sdowney717 Senior Member

    I modified my MCCK D drive pump to work with a pin drive impeller.
    I successfully using a dremel , screwdrivers, hammers, cut a slot and opened the ears, filed, ground then reformed to the proper shape for it to work.

    But this impeller I noticed the pin is held only by the rubber, not threaded into the brass. Is that the way they are supposed to be? I used some instant glue to secure the pin to the brass, dont like the idea it might slip sideways.
    Looking at pictures of a 4528, some show the pin separate, some sitting in the impeller.


    20180629_132141.jpg 20180703_153310_5.jpg
     
    sdowney717, Jul 3, 2018
    #1
  2. sdowney717
    Joined: Nov 2010
    Posts: 1,175
    Likes: 85, Points: 58, Legacy Rep: 274
    Location: Newport News VA

    sdowney717 Senior Member

    sdowney717, Jul 3, 2018
    #2
  3. sdowney717
    Joined: Nov 2010
    Posts: 1,175
    Likes: 85, Points: 58, Legacy Rep: 274
    Location: Newport News VA

    sdowney717 Senior Member

    Went for a 5 hour boat ride, gen worked fine the whole time with the new impeller design.
    I glued pin in with some instant glue, just in case.
     
    sdowney717, Jul 7, 2018
    #3
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.