Catamaran or monohull for efficient high speed craft

Discussion in 'Hydrodynamics and Aerodynamics' started by pietermariof, Nov 12, 2017.

  1. pietermariof
    Joined: Sep 2017
    Posts: 7
    Likes: 0, Points: 1
    Location: Indonesia

    pietermariof Junior Member

    Hello,
    I'm joining a competition where students will build boats with the same engine given by the organizer. It will be a time trial race and a long distance race. The only limitation of the design is that the boat can fit inside a 2.5 m x 2.5 m x 2 m box and the average Froude number of the previous participants is about 0.9 to 1.2. For addition, none of the boats is in the planing mode due to the 20 kg payload.

    Now I have a dilemma of choosing between catamaran and single hull. I've read some books or papers but none of them really give enlightment whether a catamaran/monohull is faster or more efficient (many recommend catamaran but how much more efficient and at what speed range?).
    For now I'm more into designing a displacement catamaran, but if you have any reference or experience that monohull is faster/more efficient, please let me know :)
     
  2. Boy Griffioen
    Joined: Sep 2017
    Posts: 24
    Likes: 0, Points: 1
    Location: NL

    Boy Griffioen Junior Member

    Is it sailing??
     
  3. HJS
    Joined: Nov 2008
    Posts: 481
    Likes: 128, Points: 43, Legacy Rep: 288
    Location: 59 45 51 N 019 02 15 E

    HJS Member

    Check if a trimaran can be a better option.
     
  4. pietermariof
    Joined: Sep 2017
    Posts: 7
    Likes: 0, Points: 1
    Location: Indonesia

    pietermariof Junior Member

    No, not sailing. We will use engine and propeller.
     
  5. pietermariof
    Joined: Sep 2017
    Posts: 7
    Likes: 0, Points: 1
    Location: Indonesia

    pietermariof Junior Member

    It sounds good for sailng only I don't see trimaran powerboat quite often
     
  6. TANSL
    Joined: Sep 2011
    Posts: 7,369
    Likes: 699, Points: 123, Legacy Rep: 300
    Location: Spain

    TANSL Senior Member

    "Not quite often" but there are some, very high speed, and even pentamarans. I think it's worth investigating.
    Anyway, the efficiency of your boat should be measured by being the fastest or the one that develops the maximum speed with the minimum consumption ?. Define, please, what is "effectiveness" for you.
     
  7. gonzo
    Joined: Aug 2002
    Posts: 16,790
    Likes: 1,714, Points: 123, Legacy Rep: 2031
    Location: Milwaukee, WI

    gonzo Senior Member

    At those low speeds (way below planing) skin friction will dominate. A monohull will be more efficient.
     
  8. TANSL
    Joined: Sep 2011
    Posts: 7,369
    Likes: 699, Points: 123, Legacy Rep: 300
    Location: Spain

    TANSL Senior Member

    I would not be very sure about that, I would have to check it; I would not give it as an axiom. At low speed the resistance by wave formation can be, in relation to the total resistance, high and of course greater than in planing mode in which the friction is, relatively to the total, greater.
    I guess this, without having done any number, is debatable.
     
  9. Boy Griffioen
    Joined: Sep 2017
    Posts: 24
    Likes: 0, Points: 1
    Location: NL

    Boy Griffioen Junior Member

    That would be a question? What's the speed you want to design for? A narrow hull has a more gradual transition from below hull speed to above hull speed. So you could maximise length and put the boat in the box diagonally and maybe push hull speed to 4 knots. Then you will be good until 3 knots before increase of resistance. If you want to go above 3 knots then a hull with a length to beam ratio of 8+ will probably have advantages. But depending on available power even hydrofoiling is possible.

    Just saying Video http://www.jetfoiler.com/gallery-1/
     
  10. pietermariof
    Joined: Sep 2017
    Posts: 7
    Likes: 0, Points: 1
    Location: Indonesia

    pietermariof Junior Member

    There will be 2 categories of the competition and we will have to use the same boat. The first one is time trial so maximum speed is more important, the 2nd one is long distance race where we have to finish as many laps as possible in the given time until the battery run out (usually in this category the participant will keep their speed around Fn = 0.5 - 0.7)

    I know that there is no type boat that can be the best on both categories, but what is the type of boat that will perform good enough in both categories? (in this case monohull vs multihull). Thanks
     
  11. pietermariof
    Joined: Sep 2017
    Posts: 7
    Likes: 0, Points: 1
    Location: Indonesia

    pietermariof Junior Member

    The design speed is 10 knots and yes some participants use foils (they performed well in the time trial category). However, some catamaran and monohull are also have decent speed compared to the foilers.

    "So you could maximise length and put the boat in the box diagonally and maybe push hull speed to 4 knots."

    Ah, this has been my question for a while. With the same length and displacement, will a catamaran be faster than a monohull since the demihulls of the catamaran have higher length-displacement ratio?
     
  12. Boy Griffioen
    Joined: Sep 2017
    Posts: 24
    Likes: 0, Points: 1
    Location: NL

    Boy Griffioen Junior Member

    If you can make the length to beam ratio more than 8 wave drag becomes less and less obvious and wetted surface is king. So a narrow long monohull could potentially beat a catamaran.
    Also because there is interference between the hulls. A well thought out skiff could be efficient.
     
  13. Mr Efficiency
    Joined: Oct 2010
    Posts: 10,386
    Likes: 1,042, Points: 113, Legacy Rep: 702
    Location: Australia

    Mr Efficiency Senior Member

    I think you need to publish the exact rules of this competition, to get any considered replies.
     
  14. Ad Hoc
    Joined: Oct 2008
    Posts: 7,774
    Likes: 1,679, Points: 113, Legacy Rep: 2488
    Location: Japan

    Ad Hoc Naval Architect

    Displacement cat will be the most efficient for you...given those Fn's.
     

  15. tdem
    Joined: Oct 2013
    Posts: 130
    Likes: 5, Points: 18, Legacy Rep: 41
    Location: NZ

    tdem Senior Member

    Sounds like the Hydros hydrocontest. Some videos can be found on Youtube, unfortunately they are very highly edited and don't show how well any of the boats performed.
     
Loading...
Similar Threads
  1. bluewave
    Replies:
    8
    Views:
    9,477
  2. Sillouete
    Replies:
    5
    Views:
    5,977
  3. Elias1999
    Replies:
    5
    Views:
    1,201
  4. S V
    Replies:
    0
    Views:
    1,876
  5. dustman
    Replies:
    70
    Views:
    8,288
  6. S V
    Replies:
    95
    Views:
    9,097
  7. dustman
    Replies:
    10
    Views:
    2,936
  8. Dave_S
    Replies:
    4
    Views:
    1,556
  9. Surfer Naval Architect
    Replies:
    1
    Views:
    1,122
  10. Dave_S
    Replies:
    7
    Views:
    2,145
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.