Using stainless steel screws in wooden boats

Discussion in 'Boatbuilding' started by metin_mehel, Mar 21, 2014.

  1. PAR
    Joined: Nov 2003
    Posts: 19,126
    Likes: 498, Points: 93, Legacy Rep: 3967
    Location: Eustis, FL

    PAR Yacht Designer/Builder

    If I have to cut into a fastener head, it will be the proper size bit for a bolt extractor. There's no sense in fooling around with a stubborn fastener. If it doesn't come out with a reasonable try, then drill it, back it out a 1/4" with a bolt extractor and twist it out the rest of the way with a pair of vice grips.
     
  2. alan white
    Joined: Mar 2007
    Posts: 3,730
    Likes: 123, Points: 0, Legacy Rep: 1404
    Location: maine

    alan white Senior Member

    They work alright. I just wish I could find bits for the darn thing (more easily).
     
  3. PAR
    Joined: Nov 2003
    Posts: 19,126
    Likes: 498, Points: 93, Legacy Rep: 3967
    Location: Eustis, FL

    PAR Yacht Designer/Builder

    Standard impact bits work on these little puppies, though the cheap ones will shatter, if you're "convincing" too hard. They fit in a 1/4" hex socket, so any 3/8" drive 1/4" impact socket will do. I use bits designed for impact hammers, available at any real tool supply.
     
  4. missinginaction
    Joined: Aug 2007
    Posts: 1,103
    Likes: 254, Points: 83, Legacy Rep: 512
    Location: New York

    missinginaction Senior Member

    A lot of good technique and information here. Something that I don't see mentioned is the application of torque in a clockwise and counterclockwise direction. I can't tell you how many times I've seen people break the heads off screws or bolts by simply cranking them counterclockwise with excessive force.

    I was taught years ago to work the fastener back and forth. First actually applying force in a clockwise direction (tightening) but doing so relatively gently, then working the fastener back and forth. This often breaks the fastener free after a few cycles without any heat being needed. Of course as has been stated heat will be quite helpful of the screw is really stuck in there. Just work it gently back and forth.
     

  5. PAR
    Joined: Nov 2003
    Posts: 19,126
    Likes: 498, Points: 93, Legacy Rep: 3967
    Location: Eustis, FL

    PAR Yacht Designer/Builder

    Yeah, on a rusted bolt, the first direction I turn is clockwise, mostly to see if it'll move, but also to break the corrosion bond line. I turn to a blue tipped wrench on bolts in metal, very quickly, as it's a lot easier than other methods. In wood, impact works well, but more often then not, I'm drilling the darned thing and putting an "easyout" in it.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.