Propeller shaft and propeller diameter

Discussion in 'Propulsion' started by QUICKNAVAL, Mar 19, 2014.

  1. QUICKNAVAL
    Joined: May 2012
    Posts: 25
    Likes: 0, Points: 1, Legacy Rep: 10
    Location: Philippines

    QUICKNAVAL Junior Member

    How can I get the required propeller shaft diameter and propeller diameter, given the Brake power and rpm of a marine engine. (esp. for tugboats, propeller with kort nozzles).

    Your comment and opinion is highly appreciated
     
  2. gonzo
    Joined: Aug 2002
    Posts: 16,790
    Likes: 1,714, Points: 123, Legacy Rep: 2031
    Location: Milwaukee, WI

    gonzo Senior Member

    You need to calculate the torque at the shaft not HP.
     
  3. QUICKNAVAL
    Joined: May 2012
    Posts: 25
    Likes: 0, Points: 1, Legacy Rep: 10
    Location: Philippines

    QUICKNAVAL Junior Member

    Is there any standard for minimum angle of twist of the shaft? The length of the steel shaft is to be 7 meter approximately.
     
  4. TANSL
    Joined: Sep 2011
    Posts: 7,369
    Likes: 699, Points: 123, Legacy Rep: 300
    Location: Spain

    TANSL Senior Member

    Here is the calculation of propeller shafts according to the rules of Bureau Veritas. The other classification societies use the same formula.
    It is not good to have an axis of 7 m long. You must put intermediate supports. How many: I do not know.
    The diameter of the propeller is ​​a much more complicated issue that I can not help you.
     

    Attached Files:

  5. QUICKNAVAL
    Joined: May 2012
    Posts: 25
    Likes: 0, Points: 1, Legacy Rep: 10
    Location: Philippines

    QUICKNAVAL Junior Member

    Thank you, i noticed that it's the same with RINA rules. For "P" in the formula is it the Brake Power or Shaft Power should be used?

    I'm using this formula, in getting the Torque.

    Pb = (2)(pi)(T)(n)
    where:
    Pb = Brake power in kW
    T = torque in kN.m
    n = rev. per sec.

    Then, using this formula for shaft diameter:
    Ps = [(pi)(ds)(G)(theta)(n)]/[(32)(Ls)]
    where:
    ds = shaft diameter
    G = shear modulus for steel shaft, 8.35 x 10^7 kN/m^2
    theta = mesured angle of twist, deg
    n = rev per sec.
    Ls = length of shaft

    Using this formula to find the shaft diameter have two unknowns the diameter (ds) and the angle of twist of the shaft. I was just confused.
     
  6. TANSL
    Joined: Sep 2011
    Posts: 7,369
    Likes: 699, Points: 123, Legacy Rep: 300
    Location: Spain

    TANSL Senior Member

    The rule says. "P Maximum continuous power of the propulsion machinery." I guess it's the brake power in kW.
    It has the advantage of being very simple, does not use the engine torque and is internationally accepted.
     

  7. QUICKNAVAL
    Joined: May 2012
    Posts: 25
    Likes: 0, Points: 1, Legacy Rep: 10
    Location: Philippines

    QUICKNAVAL Junior Member

    OK, thanks again,,,i'll proceed now to propeller diameter cal. :)
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.