electric propulsion

Discussion in 'Propulsion' started by Lew Morris, Jan 26, 2003.

  1. oldchris
    Joined: Nov 2004
    Posts: 8
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Isle of wight UK

    oldchris Chris Mannall

    From Old Chris in the UK

    Ihave completed the layout for a propulsion system using a Lynx LM200 24v motor, together with a Sevcon Millipak controller and one of their compatible centre off ford and astern reversing/speed potentiometer. The battery bank is 4x12vx100ah paired in parrallel and two pairs linked in series to give 24v. My charger is a KISS wind turbine 12v and up to 20a output dependant on wind speed. The whole application to give auxiliary power for a 24ft gaff sailing cruiser. Given say 6hrs usage per week at 50'60% of fullpotential power, the remaing 162 hours of charging potential more than covers the usage.

    Ido not expect to plane but the total cost of my set up is less than 2/3s of an equivalent diesel installation plus quietrunning and eco-friendly charging. The Kiss generator is particularly quiet and will not disturb neighbours!
     
  2. Dan B
    Joined: Sep 2004
    Posts: 4
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Hungary

    Dan B New Member

    After following a lot of links and reading everything I could find I was left looking at a car conversion kit motor which was not very expensive. About 1000-1500 GBP and producing up to 35 KW. The link for this is http://www.avt.uk.com/page10.html . I have to say that I have not used them or contacted the manufacturer only found this the most interestering or promising option. A controller to suit this type of motor and also not expensive Around 150$USD can be found at http://www.4qd.co.uk/
     
  3. Raggi_Thor
    Joined: Jan 2004
    Posts: 2,457
    Likes: 64, Points: 0, Legacy Rep: 711
    Location: Trondheim, NORWAY

    Raggi_Thor Nav.arch/Designer/Builder

    Have you looked at
    www.asmomarine.dk ?
    They have complete kits from approx 3500 to 5500 Euro.
     
  4. oldchris
    Joined: Nov 2004
    Posts: 8
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Isle of wight UK

    oldchris Chris Mannall

    Hi Ragnor, yes I realsie that, but by putting together all the bits oneself there is a saving of about 100 euros. Secondly, asmomarine dont respond to email enquiries and if they rely on agents the mark ups are horrendous. Regds Old Chris
     
  5. Raggi_Thor
    Joined: Jan 2004
    Posts: 2,457
    Likes: 64, Points: 0, Legacy Rep: 711
    Location: Trondheim, NORWAY

    Raggi_Thor Nav.arch/Designer/Builder

    Ok, I was in contact with them about one year ago, asked for an engine to Didi 26.
    Do you know where to find the propeller gear?
     
  6. fredrosse
    Joined: Jan 2005
    Posts: 439
    Likes: 81, Points: 38, Legacy Rep: 56
    Location: Philadelphia PA

    fredrosse USACE Steam

    Low Cost DC Motors

    Permanent magnet DC motors are available, low priced, and quite efficient. There are several suppliers of reasonably high output (fractional to several horsepower) DC motors, easy to find at robot sites. You do not need a controller, switching around 1,2,3 or 4 12 volt deep cycle marine batteries will do the job.
     

  7. dionysis
    Joined: Jan 2003
    Posts: 258
    Likes: 3, Points: 0, Legacy Rep: 44
    Location: Tasmania, Australia

    dionysis Senior Member

    Last quote I got on the Lynch LM200 motor, and their recomended controller was $2000 motor, $1000 controller AUSTRALIAN. This looks like good value.

    Just make sure you do your electrical budgeting correctly. It can be done.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.