Horizontal Keel

Discussion in 'Stability' started by adbert, Feb 12, 2009.

  1. adbert
    Joined: Feb 2009
    Posts: 5
    Likes: 1, Points: 0, Legacy Rep: 27
    Location: Australia

    adbert Junior Member

    Hehehe I'll leave it to you guys now. Getting into too much technical which I'm not familiar with as yet. I'm a newbie after all. I'll read more sailing/yacht books before I can chat to you guys.
     
  2. ancient kayaker
    Joined: Aug 2006
    Posts: 3,497
    Likes: 147, Points: 0, Legacy Rep: 2291
    Location: Alliston, Ontario, Canada

    ancient kayaker aka Terry Haines

    The horizontal appendage on the keel you showed in post #7 increases the lift/drag ratio of the keel. It works by reducing the water flow that "rolls" off the tip of the keel, causing turbulence and hence drag. It is similar to wing tiplets used on many passenger aircraft. Definitely for the performance obsessed sailor.

    I supposed you could shorten the keel with this device fitted but if you want to use a boat in shoal and tidal waters you may be better served with twin bilge keels. I doubt it would work very well if this 'wing' were run along both sides of the yacht full length as you suggest, and I can't see how it would do much of anything above the waterline except maybe as a party-sized swimming platform. Wider, narrower wings mounted above the waterline and angled to provide lift will theoretically work as a wing when one only is immersed by heeling, but if you hit a wave strange things will happen. Bit of a nuisance when you try to dock!
     

  3. robherc
    Joined: Dec 2008
    Posts: 433
    Likes: 5, Points: 18, Legacy Rep: 102
    Location: US/TX

    robherc Designer/Hobbyist

    I think Davide said that there was going to be an automatic system for moving the ballast, but I'm not sure if it waits until it's a horizontal movement, or if it triggers as soon as the boat begins to heel.

    According to Davide's numbers, the keel wings are angled down about 25* from horizontal. That's about half-way heeled-over for it to be a horizontal-motion of the bulb, but it is at least a LOT more feasible than 45*.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.