Trawler questions

Discussion in 'Stability' started by alrod, Dec 5, 2008.

  1. alrod
    Joined: Dec 2008
    Posts: 3
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Dania Beach

    alrod New Member

    I'm new to the forum and to trawlers in general, currently owning a 22 panga fishing boat and 24 foot Bayliner. My question relates to choosing the right trawler for short passages in the Caribbean area. I've read about the various designs, including KK, Nordhavns, etc. but would like something that will allow me to gunk hole in relatively shallow areas. Also, I like simplicity and the redundancy of two engines, as well as the fact that the hull design does not need paravanes.

    Previously the issue of the Mirage Great Harbor 37 & 47 and their suitability for travel from East to West Coast through the Panama Canal was raised. However, I did not find a definite answer as to whether these boats were suitable for such passage which allows for many stops along the way. Neither have I found any information from the manufacturer addressing this matter as it pertains to the GH37 class trawler.

    It is understood that the GH 37/47 are coastal trawlers not suitable for long passages, however, being that I'm considering upon retirement cruising primarily in the Caribbean, I'd like to know if a trip, for example from Key West to Isla Mujeres, and from there to Caiman would be feasable with any degree of confidence. We saw one of these boats at the Miami boat show couple of years ago and my wife likes how much they feel like a house.

    Thanks in advance for any assistance in clarifying this matter.
     
  2. marshmat
    Joined: Apr 2005
    Posts: 4,127
    Likes: 149, Points: 63, Legacy Rep: 2043
    Location: Ontario

    marshmat Senior Member

    Hi alrod,

    Welcome to boatdesign.net :)

    The Great Harbour 37/47 are interesting boats, certainly somewhat unusual when compared to other trawler yachts. Where many of the competitors have a deep, slack-bilged hull shape that often seems to have offshore fishing ancestry, Great Harbour ( http://www.mirage-mfg.com/index.html ) uses shallow, hard-chine hulls that look to be derived more from coastal workboat forms.

    We don't have any of either craft anywhere near here, as far as I know. I've never seen one in any of the nearby marinas, and they don't show up at the boat shows up here.

    From the reviews and photos I've seen, they are very much house-like and I think the spaces are a bit too open for serious offshore use. But I would think Caribbean cruising is well within the realm of their capability, provided you keep an eye on the weather. I think a couple have crossed to Hawaii on their own bottoms, although that would probably necessitate waiting a while for the right weather window.

    They seem to be very big on the complex, expensive mechanical and electrical systems. This is not an uncommon fault among large, luxurious boats. But keep in mind that all of this equipment that gives you modern landlubber luxury, is going to require a small army of mechanics and specialty technicians to keep it running.

    They claim unsinkability- an iffy claim (see Titanic)- but being essentially unballasted and built of lightweight cored composites, one would probably have a decent chance of remaining afloat in a disaster. How those lightweight cored composites hold up over time is another matter, and one that calls for a thorough once-over by a really, really good surveyor before buying used.

    They are, however, a long way from being inexpensive....
     
  3. alrod
    Joined: Dec 2008
    Posts: 3
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Dania Beach

    alrod New Member

    Thanks for the reply to my inquiry. I believe the Mirage Trawler that went to Hawaii is the N37 class Ho'Okele. See the following link: http://www.greatharbourtrawlers.com/html/hawaii02.html

    The N37 has less windage although it does share the same hull as the GH37 class. It also has considerably less living space. One of the things I've read about these boats is the righting moment capabilities that are touted. It is said that they can literally right themselves up from 180 degree submersion - I can't find the link on this, I believe it was an article by Lou Codega. My concern is the GH37 class boat behaviour in ten plus foot seas during a short passage as described above. I have not found any literature in this regard.
     
  4. Tad
    Joined: Mar 2002
    Posts: 2,321
    Likes: 214, Points: 73, Legacy Rep: 2281
    Location: Flattop Islands

    Tad Boat Designer

    Unballasted, lightweight cored construction, shallow draft, wide beam.....all these factors add up to a high sided box floating on top of the water. Motion in a seaway will be quick and exaggerated due to fast shifts of the center of buoyancy in a wide flat hull. These hulls are extremely comfortable at the dock or in flat water cruising, I doubt Lou Codega foresaw this boat being used for ocean cruising.

    A deeper, narrower, round section hull will have more motion, but it will be slower and more predictable. Also a narrower boat will be faster (more efficient) in headwind or seas.

    In my opinion there are far better boats available for your intended cruising grounds.
     
  5. Steve W
    Joined: Jul 2004
    Posts: 1,847
    Likes: 73, Points: 48, Legacy Rep: 608
    Location: Duluth, Minnesota

    Steve W Senior Member

    For your intended purpose i would think a smaller displacement power catamaran would be well suited, 2 small diesels spaced far apart give great manouverability and about as good fuel economy as you can get in a powerboat,shallow draft, lots of bright airy accomadations and plenty seaworthy for your type of cruising,the PDQ 34 would be a good choice and has a kind of a trawler look.
    Steve.
     
  6. alrod
    Joined: Dec 2008
    Posts: 3
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Dania Beach

    alrod New Member

    The PDQ 34 looks very interesting. I like the shallow draft although it is more fuel thirsty than the GH37 and with faster cruising speed. Wonder how it would work as a live aboard.

    I would not consider the GH37 were it not advertised as the perfect coastal and Great Loop trawler, that can also take you around in the Caribbean. Any other trawler suggestions that meet the low draft criteria would be appreciated ?

    Also, it appears that based on your answers, even though this is a coastal cruiser, no one would consider taking it around Central America and up the West Coast.

    Thanks for your previous and future comments.

    Al
     
  7. tranmkp
    Joined: May 2002
    Posts: 99
    Likes: 2, Points: 8, Legacy Rep: 78
    Location: Texas

    tranmkp "wherever you go. there you are"

    a mild hijack, regarding trawlers - I have switched over from the sail side - however, I too would like to do some offshore cruising - just point to point, nor more than 50-75 miles offshore. However I am concerned about the dreaded snap roll that is not so nice. setting up booms and running fish seems dangerous... active stabilizers are out of my price range.

    Seems that there is just no middle ground in hull form - trawler = very beamy for length. While a motor sailor is going to be much less beamy (living room).

    Is there such an animal as a keel centerboard trawler???
     
    1 person likes this.
  8. big-boss
    Joined: Mar 2008
    Posts: 58
    Likes: 0, Points: 6, Legacy Rep: 10
    Location: Exeter, CA

    big-boss Junior Member

    It always comes to tha same conclusion. There is no boat for the "little guys" that want to travel and explore the coastline.

    I just want to go out of Morro Bay to Alaska. Stop along the way and be able to keep it in my 36ft slip. Seems like I am always reenventing the wheel but I am not it is just not out there. Fishing boats, Express cruiser, none of them are right. I am closer to what I want with the old Uniflite I have.

    Where is that 35ft NOrdhaven for under $100K when you need it?
     
  9. Tad
    Joined: Mar 2002
    Posts: 2,321
    Likes: 214, Points: 73, Legacy Rep: 2281
    Location: Flattop Islands

    Tad Boat Designer

    alrod....

    Very experienced people can make remarkable voyages in marginal vessels. Sending noobs to sea in even very good boats is questionable. Stuff happens out there, it can turn out okay if you do the right thing quickly. Unfortunately situations that are not life threatening sometimes scare people (especially wives who don't understand what's happening).

    The PDQ 34 is again a fine boat for inland cruising, it is not intended as a full time liveaboard or ocean cruiser. It has 1/3-1/4 the space of the GH37. Load carrying will be far less.

    tranm & BB....

    We're currently working on a small offshore capable displacement power boat, the Timbercoast Troller 22'. This design will be marketed by Bartender Boats. It's not a bartender though it does share the double-ended form. The hull is a deep vee single chine form with full keel. Power is a 3 cylinder diesel of less than 30HP for 7 knot cruising speed. A semi-production aluminum version is anticipated. The 22' will be followed by 27' and 16' foot models. Pic of the 22' below....
    newcabin02.jpg

    newcabin03.jpg
     
  10. FAST FRED
    Joined: Oct 2002
    Posts: 4,519
    Likes: 111, Points: 63, Legacy Rep: 1009
    Location: Conn in summers , Ortona FL in winter , with big d

    FAST FRED Senior Member

    There is no boat for the "little guys" that want to travel and explore the coastline.

    I would look at the Ranger or other trailerable "cruisers".You can extend your range at low cost with a trailer hitch on your car.

    The problem is not SEAWORTHYNESS , its comfort. Google ,Marne Marie (close?) an early transatlantic cruiser.1930ish.

    Most folks want tiny boats to be as comfortable as huge boats , no chance.

    The use of flopper stoppers CAN be very simple and is hardly a hassle on a many day passage.

    Do not fear/dismiss what you have no experience with.

    FF
     
  11. El Sea
    Joined: Aug 2006
    Posts: 55
    Likes: 1, Points: 0, Legacy Rep: 36
    Location: St Petersburg, Florida

    El Sea Junior Member

    Alrod,

    You currently have a Panga & a Bayliner, both are great for the right application. For going to the Bahamas you can choose from any of the trawlers from 32' to what ever you can afford. The point is, watch your weather window, your sea conditions and go for it.



    El Sea,


    "It's the voyage, not the vessel"
     
  12. joz
    Joined: Jul 2002
    Posts: 166
    Likes: 0, Points: 16, Legacy Rep: 10
    Location: Melbourne, Australia

    joz Senior Member

    Tad like your pics is the two extra poles are they for looks or are they for some purpose? Also I like the stay sail did you put that in for stability reasons?
     
  13. Tad
    Joined: Mar 2002
    Posts: 2,321
    Likes: 214, Points: 73, Legacy Rep: 2281
    Location: Flattop Islands

    Tad Boat Designer

    joz....

    The poles hinge outboard to run paravane stabilizers. These are tiny, 6-10 pounds, very easy to set and retrieve. The sail is for steadying, used with a jib the boat could sail (not fast but moving) across or downwind to get home should there be an engine problem.
     
  14. big-boss
    Joined: Mar 2008
    Posts: 58
    Likes: 0, Points: 6, Legacy Rep: 10
    Location: Exeter, CA

    big-boss Junior Member

    Can you put paravanes on a planing hul? Just keep it at hull speed? Or am I messed up? Thanks
     

  15. Tad
    Joined: Mar 2002
    Posts: 2,321
    Likes: 214, Points: 73, Legacy Rep: 2281
    Location: Flattop Islands

    Tad Boat Designer

    Planing hulls are (mostly) quite stable dynamically, paravanes could react wildly at any speed over 8-9 knots and loads on the gear would be frightening.

    The Timbercoast is a 7 knot boat, see the post above. While she is a deep-vee double-ender, she is a full displacement boat. The standard planing Bartender is a moderate vee becoming flat bottomed at the transom.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.