Automotive Distributor in Volvo

Discussion in 'DIY Marinizing' started by Roboj, Jan 31, 2007.

  1. Roboj
    Joined: Jan 2007
    Posts: 18
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Vancouver

    Roboj Junior Member

    Hello there,

    I am working on my winter project, an 18 foot Excel with a 2.3 litre four cylinder Volvo. I am going over the engine, and tried to remove the distributor, only to find it was seized and broken in half. When I removed, it was junk. The distributor was points ignition and have since purchased an automotive distributor, basically the identical thing with the addition of the vacuum advance and retard. The automotive distributor is easy to find which is unfortunately not the case for the marine distributor. I will be discarding the vacuum advance and replacing the internals from my marine distributor. I will also be welding up the hole where the vacuum advance was.

    Is there anything else that I should be aware of?

    Thanx for your input.

    Rob.
     
  2. gonzo
    Joined: Aug 2002
    Posts: 16,790
    Likes: 1,714, Points: 123, Legacy Rep: 2031
    Location: Milwaukee, WI

    gonzo Senior Member

    Yes, the auto distributor is vented without a spark arrestor which makes it dangerous and illegal. Also, the advance curve is different.
     
  3. Roboj
    Joined: Jan 2007
    Posts: 18
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Vancouver

    Roboj Junior Member

    You are right, but....

    Thank you for your reply Gonzo.

    I have taken both distributors apart and there are some differences. The automotive one uses a clamp on cap while the marine one uses a screw on cap. I spoke to a shop that says they do it all the time, but that does not make it right. My distributor was cracked in half, garbage.

    Here is what I am doing, which I feel will make it as safe as the original.

    I have removed the vacuum advance and will be welding up all the holes that are not used. The spark arrestor will be screwed down onto the automotive distributor, it is just a plate and screen. Otherwise the vent holes on both are the same. The marine mechanical advance assembly will be installed onto the automotive distributor.

    Ears will be welded onto the automotive distributor to accept a screw on cap and I will convert it to electronic ignition.

    Unfortunately the marine distributor is hard to find, and if you do, expensive. I think with these changes, it will be as good as, if not better than original, because I got rid of the points.

    Any more comments are always appreciated.

    Thanx.
     

  4. gonzo
    Joined: Aug 2002
    Posts: 16,790
    Likes: 1,714, Points: 123, Legacy Rep: 2031
    Location: Milwaukee, WI

    gonzo Senior Member

    With those modifications it will be safe and the advance curve will stay the same.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.