marine vs. automotive - Vortec

vapor separators in marine use have to be closed. They look like a carburator bowl, with a float that operates a needle valve. When there are vapors in the system, the float goes down and the vacuum from the manifold sucks it in . As the system gets purged of vapors, the float goes up until the needle valve closes. I think a canister would be illegal in a boat.

 

Beech 2000, could you send me your e-mail please, I got a question for you. Thank you letsgorace@adelphia.net

 

Who makes the best manual for building the small block chevy for marine use beside mercruiser. (i.e. fits and clearances, ring gaps, torques dimensions etc...)

Mercruiser wants to much money for the oem manual.

 

There are lots of engine building books out there. One of the most respected engine authors out there is David Vizard. Here's a link to his smallblock chevy rebuilding book.

 

Thanks Stone,

Oh by the way the I chose not to boil the block but did have it FPI'ed and no cracks. I also had the deck(s) cleaned up and had each cylinder nitrogen pressure checked to 4000PSI unheated and found no leaks.

Also the both intake and exhaust valves are steel. Will be replacing exhaust valves with stainless for marine use. any recommendations?

I was shocked to see the factory did install brass freeze plugs.

So far so good..

 

I used Manleys in my engine, but Ferrea valves are also really popular with the high performance crowd. Check out Mahle pistons - they're really high tech. They use special low expansion alloy in their forged pistons, and they use special coatings to reduce friction on the skirts.

This guy is a buddy of mine: http://www.ellweinengines.com/ he's a nuclear reactor operator in his day job - the engine building is how he pays for his race car. Most of the stuff for the LT1 will also fit the vortec engines.

Oh yeah - here's his hobby site: http://www.karl-ellwein.org/

 

Jango, What PN Edlebrock manifold did you use? All I find is square bore from Summit for Vortec

 

Never mind Jango, Didn't read the ford the first time.