Hi RWatson, Its a rear engine vehicle based off of the VW chassis. So there isn't a driveline, just a transaxle. Which is encapsulated to the...
Hey guys, Im pretty much new here. I just recently finished my prototype amphibious vehicle. The hull is filled full of foam an the canopy roof...
I'm pretty sure that I have used enough foam to make sure that I wont sink, and I haven't started trying to sink it. I just meant that If needed...
Thanks for the pictures apex1 gives me a starting point. I am thinking of running a shaft off of the crankshaft into a jet pump drive...
Thanks for the input and info. Rambat I was doing some research and came across your site a couple of days ago. Good job and good luck with...
I did a test with both tires off the ground to see if both tires would move forward at te same time and the passenger side tire has power to it...
Totally open to all ideas. Right now I am running a VW aircooled motor I'm pretty sure the rotation is counter clockwise rotation. I consider...
Hi! I am new to this forum. Over the past 7 years I have been developing a new amphibian model based off of an old kit car, known as a Sterling...
Hi, I am new to this site and have made a dual weedwacker setup for the amphibious car that I have designed. I wasn't happy about the output but...