if you like contact me at rawleyjerel@yahoo.com
agreed but dont just tape the seems cover the whole box or youll end up with trouble down the line.
thats a tough situation!! if that doesnt work try making more cuts inbetween the ones you already have,like a triple cut core! that should give...
thats a matter of preference! it would be alot cheaper to get some marine plywood build your cabinets out of it using stainless screws and then...
improper preping of the surface the core bonded to and was allowed to let water in?? did it delaminate? was it wet with water/ was the core coated...
i suggest using hull and deck putty for this purpose as hull and deck is structurally sound. and catalyzed with mekp
even if you have a blood sack its on top of the peel ply making it no problem. ive infused a picknick table with no problems upside down...
you know china where they still use lead paint or where they cant make fiberglass without using a ton of starch
maybe in china but everyone else knows better
midnitmike is right try some cabosil in your gel coat to make a thin putty that will make it stay in place
ye correct the vac lines are made using tie wire spun on a spindle creating a spring, then stretched out and wrapped with a six inch wide 1208 at...
sounds like negative draft !! if it is your doomed, but heres an idea try to grab the mold on either side where its hung up and pull them outwrds,...
anyone who listens to tunnels is going down the wrong path!!!!! for one how long do you think it will take you to grind it that neat and then try...
<insult directed towards other member removed>. seems the fiberglass and infusion were invented in the united states i think that you should shut...
do you have pressure pots? if so you can regulate vac pressure by the pots. under a vacuum there is no gravity so it doesnt matter you can infuse...