This is an odd question but I need an answer

Discussion in 'Fiberglass and Composite Boat Building' started by ConchoMan, Jan 31, 2008.

  1. ConchoMan
    Joined: Jan 2008
    Posts: 1
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: texas

    ConchoMan New Member

    Ok I have a fiberglass mast and sail off of a windboard. I am planning on fixing the mast onto a flat bottom aluminum boat (also I am going to build outriggers out of some metal pipeing for the cross bars and most likely large PVC pipe for the pontoons. I feel I am more then capable of doing this as i have already done so with my canoe. Althought that was not very safe and we almost flipped it a few times. Now my question is on the mast it is made of fiberglass (made by bic) but does not have any paint or coating on it. I also know that you can get fiberglass splinters from it as I already did. Nothing large just little dust size pieces the mast is not cracked or damaged in any way. I am wonding if it would be alright to use common walmart spray pant to seal it or should I use some specialty sealer on it. Many thanks
     
  2. rwatson
    Joined: Aug 2007
    Posts: 6,163
    Likes: 495, Points: 83, Legacy Rep: 1749
    Location: Tasmania,Australia

    rwatson Senior Member

    I assume that the mast is fairly smooth despite the small 'splinters', so maybe a bit of a roughen up with 100 grit paper for a surface coating to hold on to may be in order.
    The spray paints are usually a bit cheap and nasty and fall off pretty quickly - I have had better success for less cost by getting a small can of quality gloss house paint, make a sort of long narrow bath out of something cheap (aluminium foil) and tip the paint over the mast and let it 'drip dry' - that way you get a smooth finish like spraying.
    If you have to buy the PVC pipe to make outriggers, you may find it cheaper to get a sheet of marine ply, do a triangular prism shape with stitch and glue out of three shaped panels, and get a lot more flotation for a lot less money. I have found the PVC pipe cracks and breaks easily on impact, wears out in UV exposure unless it has a fibreglass coating, so the plywood method usually produces a much more satisfactory and cost effective answer.
    You could also use bits out of the same sheet of plywood to make the crossbeams if you are a bit of a woodworker , but steel or aluminium pipe would be fine too.
    Have fun
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.