inboard well for outboard motor in a sailboat

Discussion in 'Boat Design' started by dblount, Jun 3, 2007.

  1. dblount
    Joined: Jun 2007
    Posts: 1
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: florida

    dblount New Member

    i am looking for some information on building a well for an outboard motor on my sailboat. i would like to be able to raise and lower the motor with panels on the bottom to close the well when motor is not in use. any advice would be greatly appreciated. (motor will be 10 to 15 hp)
     
  2. PAR
    Joined: Nov 2003
    Posts: 19,126
    Likes: 498, Points: 93, Legacy Rep: 3967
    Location: Eustis, FL

    PAR Yacht Designer/Builder

    There are a few engineering details you'll need to work out, but it generally boils down to a enclosed well, with a transom, set at the proper height for the engine (and well under the boat so it doesn't ventilate), a door or plug to seal the hole in the bottom of the boat when not in use and sufficient enough ventilation for the motor to breath and stay cool, without getting swamped or flooded as the boat pitches or has following seas pass under the stern.

    Each application is engineered differently and the basics mentioned apply to most. Some don't use a door, others leave the top uncovered to help it breath. Some have fancy lifting devices, other just swing up on the outboards neck (which requires a lot more space). Of course, control cable routing can make things interesting if hand controls, other then what's available on the motor, plus a few other issues that can crop up and piss you off.
     
  3. tspeer
    Joined: Feb 2002
    Posts: 2,319
    Likes: 303, Points: 83, Legacy Rep: 1673
    Location: Port Gamble, Washington, USA

    tspeer Senior Member

    Take a look at a Hobie 33. They have a system that seems to work well. There's a plug that drops into the well to seal it off, and the motor sits on top of the plug. The well is tapered and shaped so the plug aligns itself.
     
  4. JPC
    Joined: Jun 2005
    Posts: 90
    Likes: 3, Points: 8, Legacy Rep: 20
    Location: Hong Kong

    JPC Junior Member


  5. Raggi_Thor
    Joined: Jan 2004
    Posts: 2,457
    Likes: 64, Points: 0, Legacy Rep: 711
    Location: Trondheim, NORWAY

    Raggi_Thor Nav.arch/Designer/Builder

    Some clever boatbuilders have made a square, open box around the propeller, so that when you lift the engine vertically, the bottom of this square is closing the well flush with bottom.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.