Possibly - It does look like the left cone is upside down. But one pontoon is definately lower than the other. The hull is not twisted. It's just...
I posted up the pic. You can clearly see the pontoon is scew, althogh it's not so obvious looking from the front/side or close up. I'm not sure...
It has very high tensile and compressive strength. It supposedly has a higher strength to weight ratio than graphite. I don't think its strength...
Hi, I took photo's but I have forgotten them at home. I'll post them tomorrow. Thanks Wynand - I still can't access the site, Ill try again tomorrow.
I can't access Wynand's website
Ok, but as far as know a RIB under a certain size does not need to be filled with foam to attain a buoyancy certificate? Im sure my boat is not...
Ok Fanie. Ill get some pics;) . I seriously have a low budget, otherwise I would buy a different boat. The engines have no hydrolic trim/tilt...
I think so. thanks.
"The long tie rod is a poor excuse for incorrect motors mounting:o" What excuse would you prefer? I was asking a question to eliminate possible...
Maybe keels, outriggers and ballasts are not the place to look - maybe its time for other technology. Something relying less on weight and...
I think this is a fantastic project. In terms of design for disability - there are a lot of things to think about; Simplicity: Complicated...
There are other holes in the transom - but from a single engine - which is another reason that i'm loathed to add more holes. The props are not...
Thanks everyone for the input :). I have not actually been experiencing chine walk (sorry - the chine walk question was a tangent thought, but Im...
?! How do you know if you are not familiar with most of them? I use Solidworks because thats what I learnt to use during my studies. I think...
I have an RIB with twin 40hp yam's. Due to the length of the tie rod, the engines are placed farther apart than they need to be. I think the...