comfisherman's Recent Activity
-
comfisherman replied to the thread Thoughts on prop load for com-fish/tow boat.
Ah so your rocking factory stern post. Wonder if you do a keel extension would the taper add room for a bigger wheel. The 44 Hansen's...
Apr 25, 2024 at 3:06 AM -
comfisherman replied to the thread Thoughts on prop load for com-fish/tow boat.
I wish I shared your optimism for the market, but having lived through the crash of the late 90s as well as the 15/16' one this is much...
Apr 24, 2024 at 1:27 PM -
comfisherman replied to the thread Thoughts on prop load for com-fish/tow boat.
Cnf in Mississippi does nozzles. He's significantly less cost than west coast makers. In the last couple years he's done some for a...
Apr 24, 2024 at 12:10 PM -
comfisherman replied to the thread Thoughts on prop load for com-fish/tow boat.
Hard chine millenium hull? Keep in mind you gain some thrust with the nozzle but would also loose with much smaller diameter prop. A...
Apr 23, 2024 at 2:01 PM -
comfisherman replied to the thread Thermo-Lite Boards.
Its off brand coosa, Coosa is a lot like plywood in physical characteristics, although ply takes a fastener a bit better. That and ply...
Apr 23, 2024 at 1:09 PM -
comfisherman replied to the thread Thoughts on prop load for com-fish/tow boat.
Curious what hull you have. This is the light/loaded conundrum facing all seiners. Overwhelming percentage of our boats were built...
Apr 23, 2024 at 12:59 PM -
comfisherman replied to the thread Need ideas for lamination panel.
I have a table top that has a thick chunk of virgin tivar uhmw sheet. One side was smooth, we did a light sand of a burr or two and then...
Apr 19, 2024 at 5:41 PM