I bought a 14" cubby cabin river boat and found some rot in the transom. Transom was constructed of three layers of ply (1/2" ply + Grp + 1/4"...
Thanx PAR I just thought it might be a usable alternative to marine ply, seeing I only need less than a SQ foot to do a small repair on my...
A stupid question maybe, but one I have to ask. Can scrap layers of fibreglass (eg. pieces of deck, hull, etc) be used to lay-up into a sheet...
Availability of Moulds Are any of the MC-B420 moulds available? Can you send reply and costs to gvanloggerenberg@sars.gov.za.
Thanx for the reply's. I hope the pic of the mould are attached. It seems a bit dirty, but I will first check it out to see if it is usable....
Well, it seems my post was not clear enough. I am trying to do some costing to check if it is worthwhile to buy the mould. I need info on the...
After much thought I have decided to get a boat, actually building my own. I can obtain a new mould for 5.5m (18ft) river boat , but I need...
Their planning to build a windfarm here to generate electricity so maybee we will have more nice fishing days. Have a gander at Super Cat's...
Hi Fanie Were trying to get rid of the wind here, can i send you a couple of truck loads to get you started?
Hi Fanie First get the design you like and then worry about motors. The hull design would be the factor that influence your decision iro the...
Hi Fanie Try this site, the designs look outdated, but gives you an idea of where you want to go. http://www.hartley-boats.com/
Hi Fanie Stay with your idea. An alternative will be a trimaran. It will give you the benefit of "breaking it up" for trailering and...
If discussing trailer design you have to ignore the regulations and laws as they vary from country to country. Over 50 countries with each having...