First, complete your surface and lines in rhino and make sure they are fair and Ok. Then, using control point of lines, make dat files and import...
In addition to what NavalSArtichocke mentioned, Also check the visibility of wheelhouse. Low draft and a little aft trim may cause increase...
There is a way in autohydro to define the height coefficient: Defining wind pressure gradient in height. For example, using following command for...
Thank you immaculate. I'm going to prepare a stability booklet for BV and I hope they accept this method. Another question is "How do you...
Hi experts, I am going to use Autohydro for stability calculation for a jack-up. I have a question about windage area modeling for MODUs which...
You can import .iges file to Rhino and then use AttachGHSdata command in Rhino to create ghs data. Then "save as" the model in .gf format and use...
Yes. The fsm correction to be applied according to IMO IS code. If you load the tanks in different loading conditions, autohydro calculates fsm...
limit res ratio from roll to abs 50 or fld > 1 limit res ratio from roll to abs 50 or ra0 > 1 limit angle at equ < 16 roll imo wind...
The selected object for attachGHSdata command shall be closed surface. For complicated shapes you can use different closed surfaces. Each closed...
After using "attachGHSdata" commant in Rhino to define spud can sections, you shall "save as" the file in .gf formt. Then you can open the saved...
It may be too late but: You can simply use following limit definition in autohydro: limit abs ratio form abs 0 to ra0 or fld >1.4 then...
Hi petlily, just don't define drafts and don't use /km parameter for ghs command. for example following commands will force to zero heel: ghs dr...
hi, I use margin command in autohydro to define deck edge. but sometimes the line created by autohydro is not correct, for example when deck has...