Hi I've just finished a vinylester/polyester boat mold 20ft in size, How long do I need to leave it to post cure for before pulling it off...
Hi Im building a 20ft v drive ski boat, I have put one planing strake either side of the centreline one third of the way up the hull running...
cheers for the advice guys, do i need gelcoat both sides? if at all? just curoius? also what is biotope?
Hi all..... I'm building a "hard tank" setup in my ski boat for filling with water ballast to make the wake bigger, looking at building...
Well I fitted a strainer about 6 weeks ago, and thankful I fitted one, it amazing the crap that comes out of it!!! grass, leaves etc etc thanks...
does anyone know how to make fibreglass exhaust bends? very familiar with composite, just need to know how to mold the bends properly:rolleyes:
any pics or suggestions on type of strainer to use?
Hi Team just rigging a pcm zr6 v drive in my inboard ski boat for use in freshwater, is a raw water strainer neccessary? keen to hear your...
Go for it!! i started a boat repair shop in New Zealand at the beginning of this year so far so good, slow to start but beginning to pay off....
looking at the other boats out there is half the fun!! I've just finished my first prototype about to fit an engine and test it :D I'll post...