Studing WIG (Wing In Ground Effect)

Discussion in 'Boat Design' started by Geob, Nov 22, 2006.

  1. machg
    Joined: Mar 2008
    Posts: 3
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Hobart, Australia

    machg New Member

    WIG - light?

    I see the addition of "negative ballast" of Helium more as a means of increasing the efficiency of a WIG vessel, as the most energy consuming part of takeoff in a WIG is breaking clear of the water. If you can reduce the amount hull in the water, you can reduce the amount of energy it takes to break it free from the water. When I said "hovering" in this context, I was think more of being relatively weightless rather than floating inches above the ground. I see any WIG design as being more efficient by having Helium added to reduce weight, thereby reducing the amount of lift needed to achieve "flight" (for want of a better word) a reduction in the amount of lift required equals a reduction in the amount of energy required to achieve "flight". I feel this would make landing safer by allowing much slower ground (water) speeds on landing; a principle followed by conventional aircraft when they use a headwind to land.
     
  2. kach22i
    Joined: Feb 2005
    Posts: 2,418
    Likes: 111, Points: 63, Legacy Rep: 1222
    Location: Michigan

    kach22i Architect

    From what you have said, you may also want to consider an air cushion landing system, also known as a hovercraft-WIG combination.
     
  3. Gannet
    Joined: Oct 2006
    Posts: 37
    Likes: 1, Points: 8, Legacy Rep: 36
    Location: Baltimore, MD

    Gannet Junior Member

    Power Required?

    I agree with you I also find WIGs a fantastic concept.

    Considering that the Lighter Than Air concept requires the volume of air to be displaced to lift the hull out of the water would be very large resulting in a very large parasitic drag which most likely will require more thrust than what would be required to get over the "hump"

    Another WIG approach you may find worth investigating is http://users.telenet.be/heliferry/Principles%20of%20lift.html
     
  4. kach22i
    Joined: Feb 2005
    Posts: 2,418
    Likes: 111, Points: 63, Legacy Rep: 1222
    Location: Michigan

    kach22i Architect

    They have a picture of the Carter Gyrocopter on their site, a nice craft in it's own right.

    Again I must protest large rotating blades near the water surface.

    I'm not going to lose my head over it in a pitch though.:D
     
  5. Jimboat
    Joined: Feb 2002
    Posts: 266
    Likes: 21, Points: 18, Legacy Rep: 130
    Location: Canada

    Jimboat Senior Member

    All of our research is focused on the tunnel hull designs, requiring the analysis of the unique balance of aerodynamic and hydrodynamic forces for dynamic stability on water surfaces. Tunnel boats are low aspect ratio aerofoils in ground effect. It's a very interesting field. We've been doing research, wind tunnel and water channel testing, and full scale testing for 30 years.

    Check out "Secrets of Tunnel Hull Design" book, or various papers on web site.

    Call if you want to discuss.

    Cheers!
     
  6. machg
    Joined: Mar 2008
    Posts: 3
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Hobart, Australia

    machg New Member

    The design I have in my head is based around a tunnel (or catamaran?) hull type. The idea is to basically have a large WIG specific wing in the middle with tunnel type hulls on either end. I quite like the idea of a large ducted fan setup in the middle of the wing for WIG VTOL. The blades of the ducted fan could be variable pitch so that drag would be minimised once WIG flight is achieved. Would the rotation of the fan would provide a gyroscopic effect, aiding stability?
     
  7. yipster
    Joined: Oct 2002
    Posts: 3,486
    Likes: 97, Points: 58, Legacy Rep: 1148
    Location: netherlands

    yipster designer

    BELT DRIVEN Counter Rotating Planetary Drive Units Now Available!
    Increase Thrust up to 30%
    Reduce Noise by up to 30%
    Use Wide or Narrow Propellers
    Front Propeller Turns Larger Slower Propeller to Feed Rear Faster Propeller.
    Available in (3) Combined Output Ratios:
    http://www.centurydrivesystemsinc.com/ch3_counter_rotating.htm
     
  8. pilgrim3927
    Joined: Oct 2009
    Posts: 7
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Tauranga, New Zealand

    pilgrim3927 Junior Member

    Purchaser of Flightship

    The FS8 project was bought by Wigetworks in Singapore.
    Check this link: www.wigetworks.com

    They are still operational. I am currently in communication with them.

    Cheers
     
  9. rjbuljubasic@gm
    Joined: May 2011
    Posts: 4
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Makarska

    rjbuljubasic@gm New Member

  10. rjbuljubasic@gm
    Joined: May 2011
    Posts: 4
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Makarska

    rjbuljubasic@gm New Member

    If i may add my input to stepped hulls, stay away from them when building WIG planes, you want a smooth and flat as possible surface, stepped hulls displaces water and interrupts the airflow around the foil that creates lift.
     
  11. yipster
    Joined: Oct 2002
    Posts: 3,486
    Likes: 97, Points: 58, Legacy Rep: 1148
    Location: netherlands

    yipster designer

    rjbuljubasic@gm and what or where is your good wig plane design? the u-tube link seems to show a low flyer, but i'm only an amatuer enhousiast
    there are 3 types of wig i read; the low flyers, the type that can jump boats and obstacles and a wigtype that can make jumps way above its ground effect rite?
    attached an investigation on a hydrofoil wig with waterjet propulsion, fascinating. plz post your design, i'm sure i'm not the only one that likes to see it :cool:
     

    Attached Files:

  12. Bruce46
    Joined: Jul 2006
    Posts: 81
    Likes: 3, Points: 0, Legacy Rep: 49
    Location: Stuart, Fla.

    Bruce46 Junior Member

  13. pilgrim3927
    Joined: Oct 2009
    Posts: 7
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Tauranga, New Zealand

    pilgrim3927 Junior Member

    Thanks Bruce46
    I am aware of the Nelson, NZ design. Quite innovative but is it really a WIG?
    It appears to fly outside what one would call the normal permanent ground effect range and one would have to wonder if it is not legally an aircraft.
     
  14. pilgrim3927
    Joined: Oct 2009
    Posts: 7
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Tauranga, New Zealand

    pilgrim3927 Junior Member

    Yipster

    I too would like to look at the design of rjbuljubasic@gm 's WIG craft

    Have to agree the video shows something similar to the Amphistar but with an extra wing similar to that of a normal aircraft - that wing doesn't appear to do much.

    It also appears to barely clear the surface and would not be suitable for marine conditions or choppy conditions.
     

  15. rjbuljubasic@gm
    Joined: May 2011
    Posts: 4
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Makarska

    rjbuljubasic@gm New Member

    thanks for your input and the document about the massive wig plane design. I am busy with a animation video of my craft and should be completed soon
    the frontal stabilizer clears the water and should be at 1deg angle of attack at 170 knots fully loaded, this wing allows for straight and level flight at a wide range of operating speeds, but its main function is structural. About the choppy seas, NOT OPERATING IN THESE CONDITIONS,
    I am building this craft to work, I do not have enough money to build prototypes, this is why it is shorter than 12 meters, As to maritime law, I have to pass a float test, and I need to comply with a minimum speed of 5 knots. There are more regulations on the hanger where it will be built, than on the boat itself .
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.