Way too many bubbles and must of stirred it too fast but I found a piece of pallet oak and cross grain it and will need more advice on installing...
One small air pocket not purging enough. Tried grains both ways with very small cracks but with the grain it acted like a concrete fastener with...
So a loose fitting dowel with epoxy.
I have some 20 year old treatment 2x6’s and could go back and cut again correct for a tight or loose fit but thinking is it wasted energy and just...
I might scratch the idea of the plug I cut with the grain instead of against but order some extra slow curing hardener with resin and filler from...
Not sure on engine weight but it’s a GM 4.3 V-6 Wellcraft deep v 19” ft inboard/outboard operating in a smooth river inland occasionally crossings...
Ok I’ll pick up some Epoxy at Autozone and get mixing. So I guessing my procedure is to mix 3-4 different batches and add each batch before...
Just asking but I have a un opened $50 tube of 3m Panel-bond for bodywork applications. 3 packages of Epoxy is about same price.
Had to hole saw a broken lag bolt out which held down the rear fixed motor mount and need to plug it. I made two different new treated dowels,...
Missed this summer with one problem after another and hopefully soon with all yaws help. 1993 Wellcraft
Ok I’m going to go find a larger T handle for the easy out bit. I borrowed two small ones and broke them both.
Do you recommend replacing with new? The boat is a 1993 and I order new one but weight nothing, $50 on Amazon and missing a rubber washer on...
Could I offset one front motor mount if I have problems removing the broken lag bolt drilling two new holes?
Yep! So next if can’t get broken bolt out can I spin a little and drill two new holes on that one side. I wouldn’t be able to adjust left to...