I only need 3-4 inches for it to run in, the Motor is a 49cc mini-bike motor.
The cap is to fill the transmission fluid. It also houses the location for the shaft lock, so that the shaft can be removed at anytime.
Finished the new hybrid a little late for early teal, but it will be ready for the regular season. [IMG] [IMG] [IMG] [IMG]
I am interested in this kit. How much would it be with the engine base?
Are you building something similar? I would like to try something else, if possible. I am using the 59cc motor and I am not having any kind of...
The prop is made out of die cast alum. It is a Young's Prop. I do not think that it can be bent. I could always lock out the clutch and solve the...
Could that be done by lowering the motor down, which would also reduce the angle of the long tail/shaft?
I went duck hunting this morning with my new 59cc long shaft mini motor that I made from using this form. It went through the weeds great and it...
wallyeye, It is a 5mm square end. At least that is what the machine shop told me that machined the shaft for me.
Runners I have not gotten a good test with it yet. First of all I was in a small pond and I couldn't get up to full speed. The second thing is...
You can try it but it will eventually snap!. Those shafts can not take the torque of the propeller in the water.The stainless steel shaft is only...
I got my motor off of ebay. It is the same motor that is used in the mini bikes. If you have any questions about my build give me a call.
UPDATE OK Guys... Here is the update... The mud motor ran great and i did not have any problems with it. I was in a residential...
Done! [IMG] [IMG] [IMG]
My MM Here's my mud motor. Its almost finished. All i have left is the welding. [IMG] [IMG] [IMG]