HI Does anyone know how to extract the Resistance value once the simulation is complete from Numeca Fine Marine? I am new to the software and...
Hi I am relatively new in Navcad. Can anyone provide me any tutorial link or explain how to do catamaran resistance analysis in Navcad. I am...
Yeah thats true. I also figured it out since F.Length calculation was running at very low displacement (mentioned above) & I was getting...
Hi TANSL I found out the solution for the problem. Its the Margin line . Since I have slopped transom so maxsurf somehow include the transom...
The only thing that I found out is that it works for small amount of displacement like 20 to 30 Tonne. But if the displacement is bigger which it...
The same error occurs with your given attachment too.
Hi In the criteria I set immersion criteria as Margin line immersion and also checked maximum trim angle, GMt and GMl criteria.
Hi I was trying to do floodable length calculations on hydromax. I did set Trim(LCG), VCG, Displacement range and criteria as shown in the...
Find the attached loading. Vessel particular: LOA=41m LBP=36m B=09m D=4.8 Draught=3.8
I was doing a Sever Wind and Rolling criteria calculation for a fissing vessel. But my vessel always fails. What is the remedy when a vessel fails...
Thanks for your reply. As far as I know no oil tanks are 100% filled because they leave space for oil expansion. But my question is I did not find...
