Ugh tell me about it....This thing is in the garage and needs to some work before I can drag the boat in. I'm putting in a new radiator support,...
and the angle and straightness of transom..... [IMG] [IMG]
Hopefully these came out ok...... [IMG] [IMG] [IMG] Not too bad!! My major concern is the stress cracking of the transom it was on,...
Yup I know whatcha mean!! I was getting new cables for the boat at work today and was talking to the guy about what I was planning on and he...
Thanks guys.....no cutting just filling!!
So you suppose I could safely and without effing myself later cut a notch down to the reinforced part, about the same width as the hole? And...
In the 4th pic where the trim is, right at that line the wood stops and its just a thin fiberglass layer from there up (or just above the bolt...
I've had some practice this winter at rigging up controls.....we clean up oil spills and do quite a bit of on the water work, so we got a boat...
I'm not sure if I could get just one outboard, but I could get them, try to sell the other....or keep looking for something more manageable, like...
First off, I'm new and have found some good info here already!! And now... I got a Hawiian jet boat, which had an OMC unit and a 350 chevy...
