I haven't read this whole thread, so please excuse me if some one else has posted this. I think what your proposing would operate in the water...
Definately trailerable, depending on where we end up buying it would most likely be kept on a lift when not in use.
That would be my first choice, but I'm not against other brands if I see a compeling reason to go that route.
Thanks for the replies, it's about what I thought. I ask as I'm looking at buying a new boat with the intent of keeping it when I retire to...
I realize this will likely vary by manufacturer, but is there a significant difference between Marine outboards and their fresh water brethren?
This plus one additional comment. If you want to use brass/bronze trim, use a white paint that is on the warm side, a touch yellow or creamy. If...
Gonzo is right on the money so to speak. You're close enough to the great lakes that there are a lot of reasonable priced fresh water boats around...
I don't see how you could apply that type of device on a boat, they function only when the car in in a spin....
Good stuff Jim. :)
This would be my thought, get the pilot, co-pilot and motor in still air behind a fairing and clean up all of the airflow. I'm not an areo expert...
Very common in my neck of the woods for pontoons. [IMG]
I agree, I work with 3D printing, 3 axis, and 5 axis mills on a regular basis. This 5 axis is capable of cutting a full size suburban (22' x 8')...
#1 would be better than #2, but personally I would set the boat up with the floor level and let the other lines fall were they may....
Using the same principles’ as Viking Norths method you can do the same thing with the hull upright if you have a grid (think tile squares) on your...
