From memory you need to undo all 6 nuts to remove the ally spacer in the middle. Depending on your setup, I was able to remove what was the...
I used these guys in Leeds. http://www.controlsandcables.com/ Mine had an old Morse part code on it which they no longer did, but from memory...
I'm starting to feel very guilty that you're onto a new project already and all i've done is prop the cover up to stop water gettin inside the...
Not sure how much this will help but a copy of the manual can be found here:...
That's my understanding as well. It sounds like you've got too many spacers in there to start with. I'm sure in one of the other PP65 posts...
Now you've got to hope An Post don't loose it :D Only 6 months till the water is warm enough to use the boat again!!
I wouldn't be pinning your hopes on a cast aluminium one!!
You must have done something seriously bad in a previous life :P
It depends what you need?? Bearings and seals are available from local bearing/engineering suppliers. I've uploaded the parts list in this...
Liam, Does that mean they couldn't repair your original?? It'll be interesting to see what the damage for a new one is.:?: Regards Dave
Liam, excellent news. Out of interest did Sam give you a ball park figure for a new one?? Regards Dave
Liam, As my jet is in bits on the bench at the moment, i'll measure mine up tonight such that if it is the same you could potentially get a new...
It's definitely not a west end like mine. Someone posted a similar question last year on :...
It might also be a West End unit. The impellor looks very similar to the one in mine which also looks very much like a PP unit. The only...
Anthony, Cheers for the reply. When i first got the boat i thought it was a PP65 but the fact "West End" was cast into the reverse bucket gace...