Hi All, Any help would be hugely appreciated. I have a question about both the bending moments and deflection equations for stiffeners in...
Perfect, thanks for your help
I am still unsure of what the correct procedure is. Once the fiber weight of the panel has been found, this fiber weight is then used in the...
Thanks for the reply. So say if it was chop strand matt and in ISO C for a complex panel you must use a fiber weight of .25 and the derived...
Hi there, Wondering about ISO B properties. So if you do the small amount of testing required to validate the fiber weigh fractions used, must...
Sorry, must have been looking at an older version...I have looked at the most recent and this correlates so this must have been a mistake.
Hi there, I have been puzzling for ages where the values of Qi comes from in Table H.4 in ISO 12215-5. the value is 7.07x10^8 which is in the...
Does anyyone know where the loadpoint should be taken for a WT bulkhead. Is it a third of the way up the bulkhead or half way....A little confused
Thanks Ad Hoc
Does anyone know if you are able to use the CSM tie layer in the minimum skin weight requirement for DDNV high speed craft?