Powder coating it is! Thank you all for the thoughtful input.
Anodized or powder coat or ...
I'd like it to come in at 40#. I have looked at canoes but, for instance, the 13' Grumman weighs 60# - too much. Wouldn't rule out auxiliary...
My forum search didn't find anything. With hand tools only, I'd like to build a small, rowable (as opposed to rowing) boat suitable for a single...
I'm seeking experiences regards which of the two will look better after several seasons. I have seen powder coat fail during that span of time...
I have a decision to make regards the finish on aluminum window frames. Anodizing or powder coating are the options. These are Diamond Sea Glaze...
My ticket was limited to small craft but I have an opinion and I'm having some trouble with attributing this disaster to bad luck. Why was it...
TANSL! Thanks! Precisely that data I was seeking. Somehow the recommended thicknesses are less than I would've expected. Now to make a...
I've tried but my efforts have gotten just a sales pitch for membership or handbook purchase. Excessive for someone considering his own build,...
This is very close to the boat that I have in mind: http://www.aj28boats.com/pages/basicrec.html
I mentioned hull speed capabilities only to provide a rough image of the boat itself, not by any means are these the speeds used in these...
The SNR is just too low there hence my asking the questions here. I'm far more confident of the data / advice given here.
Am considering building a so-called semi-displacement workboat of about 30' x 11'. Top speed of about 24 and a cruise of about 14. Now the...