Thanks Herman, the joint in on the inner shell in the deck area. I will go with the 1:8 tapper fill with glass and then finish with epoxy filler.
I have two section of fibreglass which a need to butt up against each other and join. I was going to use polyester resin with 4 layers 450gm CSM...
I was planing to go out in the boat tomorrow, but I found out today I can't get a GPS fix in my Navman 5607 tracker. I have tried to restart the...
Thanks Guy's, Setting the height with the cavitation plate parallel seemed the only way, but you never knows sometimes. Bruce
Hi All, :) I have been rebuilding a 6-meter fibreglass boat off and on over the last four years, and I am nearly there. I have just...
Morning all, I need to fit a new rubber strip around the gun-whale of a fibreglass boat that I have been restoring for some time. I removed...
Hi there, I need to fit a new rubber strip around the gun-whale of a fibreglass boat that I have been restoring for some time. I removed the...
:) Is there a good method of smoothing fillets and radiuses made using plasticine in the corners of a one shot mould? They look pretty smooth...
That was my first thought, that the hull had some wax or something else on it as well. However it's an old hull and was badly weathered, the Gel...