Dear Fiko I have seen your file, but some data from it. I still don't understand. 1. On Result tab you wrote T Ap=2.609m and T Fp=0.85m but on...
Thank you very much for your file Fiko. I will see it and if some problem occurs i will ask you again. I hope you won't refuse my question.
Hi all After we have all figures from inclining test. How could we do calculating with them for getting exactly data for the ship like...
Thanh you very much for your advice Jango. That 's exactly what I want.
Have any document or suggestion about relation between machine power and weight of cargo for cargo ship (under 10000T). Could any one give me...
Sorry Thai I don't understand you why we use roll angle (goc chong chanh) in Hydromax? Because of the program uses according IMO rules (I think...
Raggi_Thor Thanks for your advices. But I still understand how you can draw a section (see attached please) with 5 point like that
Thank you for all Raggi_Thor sorry, I could'nt understand how can you draw a section only 5 points? May be you are right in the case we draw...
Thai I don't understand what you mean "roll angle"? But in my opinion when you do analysis KN values in Hydromax. You can put values of heel angle...
Thank you for all advices We have initial 2D drawing design and we have to do accurate with that. I affraid of when I redraw the new curves with...
Thank you very much for your reply but when I use that commant. The hull is also not good (see attached please)
Hi I did my project (the bulb of the ship) by Rhino which I attached here (I had them from Autocad see please...