Thanks.
Thank you very much.
Thanks. I might test something unimportant out on the wax paper. I'm not really familiar with all this, what is mold release and where can I get it?
This isn't about boats, but I needed someplace to ask about fiberglass use. I am fiberglassing a small part, and the problem is I can't just...
For all of you that are saying this idea wouldn't work, have you tried it? I'm not saying it will, but no one really knows if it will until they...
Thank you, I got it to work now.
I unchechecked the corner checkbox but it keeps rechecking itself. :confused:
I smoothed all the curves as you suggested marshmat. The keel was the hardest, and still isn't perfect by any standards but I think it is much...
Design: Take 3 Tweaked the design, lost the sharp chines, narrowed the beam 6", moved the cockpit (or whatever you want to call it) forward 1.5'...
The halyard would work assuming to other boat traffic, which unless its a private bay or something. is unlikely, and I don't know if pulling...
So are you saying to completely scrap the sponson idea and use tabs instead of to use a combination of the two?
I made the indent in the transom mostly because it was easier, and I didn't see the difference at the time, I know do. Good thing I saved the...
If making your own electric outboard is the way you want to go, look into cordless electric drills. I couldn't tell you how long they would last,...
Although the thread has wandered a little, I'd like to refer back to the original round kitchen idea. The problem about the kitchen spinning...
