We were actually lucky enough to "aquire" the PVC for free. We did have to purchase the caps and elbows and they weren't cheap either.
PVC will work although it's heavy and expensive. Check out the "Riff Raft"........
Actually, while we were assembling the pipes they were somewhat "naturally" pressurized. I could tell while putting the last cap on each section...
The piping layout is as shown in this pic.... [IMG] The pic of trailer shows how we had to load the pipe for it to fit best. We did a...
Thank you for your compliment and concern.
We'll most likely just fab a mount like this one.... [IMG] And the talk about lights and railings was mostly drunken banter. There was also...
We're not sure how to mount the motor yet, but I don't think it will be to complicated. We're going to use our existing Minn Kota 50 lb. trolling...
It was a lot of fun, and a thumbs-up would suffice. We are going to register it as a homemade boat so we can mount the engine on it and go,...
It will work! My buddies and I just did this. We had four of us, a table, an umbrella, cooler full of beer, four chairs, sirius satellite radio...
