Got to laugh. I almost as old (54) and have been using computers and networks since I was 18 (36 years). I did networking for a Fortune 500...
With the proper anodes ! :D
First, you need a lifting ring. Don't screw around with straps, etc. Pay the $50 (or whatever) and order it from your dealer. Be careful, there...
REPEAT First buy this book Runabout Renovation If people followed the authors method of replacing a transom, there would be no voids. His...
While not "submerged", we use a lot a salt on our roads in winter to melt ice and snow. Also, steel is not aluminum. I think the point I was...
A bit off the topic, but adhesives are used to "strengthen" steel to steel joint in automotive unibody applications. The Ford Mustang...
Slipping any clutch for long periods of time will cause it to fail ! The Honda/Yamaha home generators vary engine speed depending on load but...
Turbo Diesel Outboard Turbo diesel outboard ! Q and A from Scream and Fly 2 sizes. 2.3L and 3.0L I4. Estimated weight of 725lbs. No HP...
The "rivet guns" I have seen, shoot "pop" rivets, that leave a hole. Fast, but are you going to trust sealant on that many holes ? The (home...
The problem with aluminum is that the initial cost of the equipment is high and poor technique will give you poor results. Someday :rolleyes: I...
First buy this book Runabout Renovation Easy to read. It is a bit old (Copyright 1992), but I don't think much has really changed since then. It...