Update on the new pod: I picked up the new pod a few days ago it’s in much better condition than I anticipated from pre delivery images. [ATTACH]...
the transom is 45" don't think about transom height. when using a pod the pod size determines what lenght shaft you can use. a 16" height pod can...
I would like to modify a outboard bracket from V bottom to a flat bottom, basicely reducing it's height from 19" down to 16" in order to fit a 20"...
I’ve ordered another prop. A brand new OMC Viper14.75X19 stainless steel. [IMG] [IMG] [IMG] hub has some corrosion maybe a wire wheel can clean...
I don't use joogle much I use Duck Duck. 4850 sounds way low I'm assuming this is for folks w/ low pitch that prioritize hole shot over speed. me...
I think the pitch is correct at 19 w/ WOT at 5500 w/ engine tucked. then when I trim up a tad RPMs slitely increase maybe 200RPM. it's hard to...
Update:these series of shake down where done w/ same not perfect 14.25x19 prop. engine lowered at rest made a significant improvement in...
is this a cupped prop.? Michigan / Evinrude 14 1/2 x 19 Aluminum Outboard Propeller # 011008 new michigan wheel prop. an are there differnt...
I used all available downward adjustment lowered 1 1/2". [ATTACH] I lowered the engine w/ all the available downward adjustment. [ATTACH] here's...
You're correct I had it backwards. I think the optimum WOT RPM for the ETEC is 5850RPM (unsure if thats aluminum or stainless steel) I have read...
the new ETEC came w/ a 14.25X 22 [ATTACH] cupped type prop. [ATTACH] this Viper prop is almost perfect, minus that smallish ding in one fin on...
a few friends just started referring to me as the brain. I'm cursed w/ way to much intelligence.
the solotion was to upgrade to the Ray pro 5 [ATTACH] the pro5 blue toothed to the 10" tablet enabled me to view anywhere on the yacht cubby to...
Barry all good infor here have you sean my threads on the fuel tank relocating? first shakedown stuff prop not 100% a few imprefections no...
