:) Acutally I was trying to define the cost of the equipment (cylinder, pump, etc) that I would need... But off course I would appreciate your...
thanks a lot for those precious information... Thats very important for me :)) now I can work on that.. Thanks..
One last thing then, is it better to have it deep or long ?? 50 depth x 40 long ?? or 60 depth x 30 long as you mentionned ??
ooppppsss sorryy hehe, please forget what I said.. just getting late here heheheh :)
I am not sure if I understoos correctly : My lateral plane area is 7 M2. 5% = 0.35 M2 0.35 M2 % 2 ( 2 rudder) = 0,175 m2 for each rudder...
Thanks a lot. This is exactly what I ment. I will probably need rudder effectiveness when maneuvring in marinas. My lateral plane area is 7...
Hey, I read a lot of threads about rudder area. My boat is a 37 feet lobster boat. I will have twin 150 HP on that. From what I read, I need to...
if you use two rudder, would that be 5% + 5% or 2.5% + 2.5% ?? thanks, just working on mine, but I will have 2 rudder for dual engine...
Actually then engine horsepower is drawed from the design hp/speed graphic. at about 270HP, I get about 18.5 knots speed. But I didn t buy the...
Hey guys, I am planning on setting up the electrical system of my new boat myself. The boat is a 36 foot wooden built riva/lobster boat type....
Would you guys rercommend I mix anything such as West Microfiber to the resin when applying the inner side of the boat ??
ok thanks, I never Heard of it ... hehe
Ok I think I get the point. Thanks... Richard there is one epoxy on the Turkish market called "Teknomarin" ERA 4000. Did you heard about that...