originally i intended the keel to provide for ballast and storage. batteries, water and precast moveable cement/scrapiron fitted shapes (about...
also ability to beach and maneuver in shallow waters. i'm pretty close to sold on a complete keel resection at this point.
the box keel is even bigger than what i had anticipated. i originally ran the bulkheads down about 7 inches below the bottom of the hull and...
sounds like it might be better to cut the keel box back to the hull and start over. with that. any further suggestions? should i put a weighted...
here is another angle of the roughed in transom, cockpit, coamings, companionway etc. the hatch is formed from plywood and then i have...
not too sure on rig or sail footage 125 sq ft?. i could definitely use help on that. probably going to attempt a birdsmouth mast or two and...
i think what you are noticing are discolorations in the plywood from earlier applications of epoxy and wood flour. the glass to hull process went...
i'm posting this because i started a project several years ago. i wanted to build a small sailboat with a cabin. i have gone through a number of...