Structure is all finally welded what a nightmare. Progress should hasten somewhat from this point forward
Front floor structure somewhat mocked up
Been awhile I had a busy summer guys but it's cold again so I'm back in garage working on this boat. We got the engine and pump in place and lined...
Can't find a stock 4.8 dyno graph but this is the 5.3. The 4.8 would follow these curves precisely just 10-15 hp less. The numbers are inflated...
Gonzo so the 6" tall stringers will span from the transom to just in front of the engine where there will be a bulkhead. This bulkhead will serve...
Thank you Barry lots of good points here. The reference I made about the similarities between this hull and the hulls used by these folks I spoke...
Good question hard to say for sure on the weight. The pump is roughly 140 lbs altogether with the intake. The engine is an iron block over 400...
Any insight or pointers would be greatly appreciated! Building this to run local rivers that are littered with logs so I will be covering the...
[ATTACH] [ATTACH]
New here figured I'd share my current project. Started with a 15 ft aluminum hull with a small outboard. Marinized a '05 4.8l gm LS V8 engine....
I know this thread is old but for people scouring the web looking for info on jet conversions it's staggering the misinformation that's tossed...