zzzzzzzzzzzzzzzzzzzzzzz
I talked to a local boat builder and he is telling me to grind off the top , put resin on it and leave it. He is telling me the strength comes...
Finally glassed in the stringers and I'm beat. Took about 6 hours to do. The good. The floor and sides laid down perfect. Bad news. The top...
White and green are the only colors good for attracting fish inshore. I do a lot of dock light fishing. I only fish those two types of lights....
Went in and set the transom in. I had some small gaps so I made some 1 and a 1/4 chop strand filler and filled it in. Used screws to make it...
Another long day at work then to the boat. Just got home and beat. I sanded both sides on the bottom for the other 2 stringers. cut and married...
Worked 5 a.m till 5 p.m today then 5pm till 10;30 pm on the boat. Grinded the transom and forward 24'' and then center for stringer. Tomorrow I...
From what I'm told the epoxy has a wax built into it that comes to the surface when curing. The wax has to be scuffed off or the next layers will...
Nice idea. The epoxy I'm using has wax in it I think I was told. SO I have to clean and scuff the wax off with 40-60 grit so the next build ups...
Just got home from a long day. Scuffed the rear and started the transom. 3 layers thick . Now to wait for her to cure and start scuffing again....
I know. I plan on adding 3 stringers and 6 - 8 bulkheads. There will be 3 top flat decks and two lower flat decks.
Work has been kicking my but so I haven't had much time till this weekend . Raising the outside edges 4'' higher. Finished the outside layer....
Today I went in and she is solid like a rock. I decided to sand out the air spots and rough up the rest. [img] [img] [img] [img] [img] [img] [img]...
When I say low spots I mean mark where the gap is front to back. Then do lay ups till I reach perfect level again. Or not stress it since I'm...
The good and the bad news . The mold came off easily. She is still soft so I'm thinking she isn't 100% cured yet since she's indoors. The lines...