Recent content by sharkbite

  1. S

    corrosion of aluminium keel by ballast-advice

    I have spoken to some professional metal boat builders who advise against overplating/doubling the keel as they believe it will sweat in-between the two plates. This can cause stresses if the boat goes into cold regions and force the welds apart. I am not planning on going polar but would...
  2. S

    corrosion of aluminium keel by ballast-advice

    Hi Gonzo. I should have been more elaborate, the line of pits is horizontal at mid keel depth where the ballast stops. Above there is smooth and pit free. I will have to do thickness testing below that line to determine whether the ballast has been interacting with the plate. So worst case...
  3. S

    corrosion of aluminium keel by ballast-advice

    Thanks, I can't see that I will achieve a decent bond with the sides with epoxy, not knowledgeable about chlorinated latex but will investigate. May have to live with an anode in the sump forever. Not the worst outcome especially given metal fittings natural gravitation to the bottom of the...
  4. S

    corrosion of aluminium keel by ballast-advice

    I have purchased a 40' aluminium Finot "Reve de Seychelles" 1980. She has been poorly maintained and now that I have finally removed decades of oil and gunge from the bilge I found pitting of the plate inside the keel where steel ballast has come loose from the polyester resin used as ballast...
Back
Top